| Informational Websites | ChronoMaddox -- the legacy of Chuck Maddox | OnTheDash -- vintage Heuer website | Zowie -- Omega information |
| Discussion Forums | ChronoMaddox Forum | Heuer Forum | Omega Forum |
| Counterfeit Watchers | ChronoTools Forum | ChronoTrader Forum |
|
|
The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998. | |||||||
|
||||||||
|
||||||||
 |
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003. | ||||||
| |||||||
| |||||||
Hi Victor
This might help you even though it is not an answer to your question.
From Cousins UK I have had these two, but had to return both because one was too big and one too small.
- Chronograph Pusher Tube Tool Spline Ø3.33mm
- Chronograph Pusher Tube Tool Spline Ø3.65mm
Therefor the other Cousins sizes Ø3.05 and Ø4.10 can't be the right.
https://www.cousinsuk.com/product/pendant-tube-chronograph-fitting-removing
Peter. Denmark
: Hi All,
: In the midst of an Autavia restoration and find myself in need of a
: new tool! I cannot measure accurately enough the spline diameter
: on my watch as I get such little room with the calipers - is it
: a 3.50 or 3.60mm tool that I need to remove them from the case?
: Hopefully someone in the know can enlighten me!
: Thanks, Vic
| Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. | CONTACT | TERMS OF USE | TRANSLATE |