The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
Re: Heuer 1153N case restoration
In Response To: Heuer 1153N case restoration ()

It is possible. Cots for an Autavia are at 150 euro. For the Carrera its probably close to 200 euro as it is the more trixky case with the small ring on the beeing polished whilst the rest is brushed

Alex
: Hello,

: I've had conflicting advice recently about
: whether it's possible to restore the case of
: an over-restored (ie polished) Heuer Carrera
: 1153N to its original brushed state; several
: watchmakers I've been to have told me that
: it's not possible because the bezel was
: pressed on the case at the factory (&
: therefore cannot be removed to enable the
: case to be put under a lathe) but I've also
: been told that this bezel can in fact be
: removed quite easily. I'm unwilling to let
: someone have a go at doing this unless I'm
: pretty sure that they'll be able to remove
: the bezel without damaging the case, so any
: advice on this subject would be very welcome
: indeed!

: Thank you,

: Kayne.

Messages In This Thread

Heuer 1153N case restoration
Re: Heuer 1153N case restoration
Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE