| Informational Websites | ChronoMaddox -- the legacy of Chuck Maddox | OnTheDash -- vintage Heuer website | Zowie -- Omega information |
| Discussion Forums | ChronoMaddox Forum | Heuer Forum | Omega Forum |
| Counterfeit Watchers | ChronoTools Forum | ChronoTrader Forum |
|
|
The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998. | |||||||
|
||||||||
|
||||||||
 |
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003. | ||||||
| |||||||
| |||||||
Hi all,
as many newbies, servicing my first Cal.12 and reinstalling the cap jewel unfortunately I have broken one of the Incabloc "lyre" shaped springs (the golden spring of the Incabloc assembly at chrono plate side) while I was trying to reinstall it after it fell off from the support...
As I need a replacement to finish the movement service, I ask if someone can tell me which is the correct type.
Surfing the forums I think it should be the 175.03 type, but I'm not sure, see below the BECO Technic website:
http://www.beco-technic.com/index.php?cat=c5214_Spring.html
I found this chart but is too little to be readable:
Any help is much appreciated.
Best.
Gianluca
| Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. | CONTACT | TERMS OF USE | TRANSLATE |