The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
Re: Help is needed with carrera

: Mark many many thanks
: With your help I have got a new price from the seller: 700 euro.
: I have found the pusher I need, I think,

:
: http://cgi.ebay.com/Tag-Heuer-Factory-Pusher-S-S-fluted_W0QQitemZ250399057523QQcmdZViewItemQQptZLH_DefaultDomain_0?hash=item250399057523&_trksid=p3286.m20.l1116

: What do you think?
: Juan Carlos

First off, I think that's a nice reduction.

The pusher looks about right - just measured one of mine on an 1153 and it is also just over 4mm in width (using a tape, no micrometer to hand) so the eBay one looks the right size too. Not sure about the internal fittings and I don't really want to start removing pushers to check! Could well be ok though, I don't think there's not a lot of variation in pusher function really.

I think it is a good choice to replace the pusher though - a minor thing, perhaps, but if it were my watch I think it would annoy me a little bit every time I looked at it, whereas I can live with case dings.

Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE