zOwie Omega Discussion Forum

Jalle's 3m product looks interesting but at 500-600 grit apparently (per the website)I think its too rough and will take off too much metal, not the mention the engravings.

This is my standard post on this subject. The results are easy to obtain and will result in minimal metal loss.

Some people use Scotch Brite, but in my view Scotch Brite is very coarse and will leave noticeable swirl marks under a variety of lighting onditions. Others use very fine sand paper. I believe that sandpaper could take off more metal than necessary.

My solution for the removal of scratches was the purchase of a fine Satin Finish Bar, item FB-1103 from Frei and Borel on the TZ Tool shop. Its around 10 dollars (USD). It is a hard sponge-like impregnated rubber block and I've had excellent results with it. For deeper scratches use their medium satin bar first. Its more abrasive. Finish up with long, slow, straight lines with the fine bar. The finish you'll get is extremely close to when new and should be a major improvement. Be careful not to touch the crystal with it. Do not use on polished surfaces, only brushed. Also be careful of the engravings on the clasp.

The medium bar, and the fine bar to a lesser extent, is abrasive and continued use will take off metal over time. The following is their text:

'This abrasive-impregnated rubber block provides the kind of brushed and satin finishes seen from the factory. I have never been able to reproduce it with any other abrasive of any type. The block, or squared pieces cut from it, should be used in very straight, light, even, uni-directional strokes over the entire length of the surface. Blow the surface free of debris between strokes for the most even finish. This is an indispensable product for those refinishing brushed and satined surfaces'

FB-1103

Around $10.60 USD

I've demonstrated the process for my authorized dealer and he agreed the results were excellent for very little effort. I hope this helps.

Mark