The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum

zOwie Omega Discussion Forum

Opened July 1999, zOwie is the Internet's first and longest running discussion forum dedicated to Omega brand watches.

Feel free to discuss pricing and specific dealers. But 'for sale' postings, commercial solicitation and ads are not allowed. Full archive of all messages is accessible through options in the Search and Preferences features. Privacy, policies and administrivia are covered in the Terms of Use.

For the answer to the NUMBER #1 most frequently asked question here--for details or value of a specific older Omega watch you have--go to: Tell Me About My Omega. Learn more about How To Include Photos and HTML In Your Postings. To contact someone with a question not relevant to other readers of the forum, please click on their email address and contact them privately.

winding required?

Keith, thanks for your previous response, below.

Here's a follow up question: from a dead stop, is manual winding required? when i first received the watch, it was at a dead stop, but instead of manually winding the crown, i only moved the watch back and forth until the second hand began moving. so, if i've never manually wound the crown, what's your recommendation? thanks. --Gary

: So, I'd take it easy, and let someone else
: address that.

: See this link
: http://fejack.net/misc/gmt24/gmt24.htm

: The Omega Seamaster GMT has 3 crown positions.
: Position 1 (just unscrewed) is for manual
: winding. Position 2 (pulled out one notch)
: is for setting the Regular Hour Hand.
: Position 3 (center position) is for setting
: the Red GMT Hand, the minute hand, and
: hacking the second hand.

: The setting procedure goes as follows: Unscrew
: the crown. From a dead stop, give the crown
: 40 - 50 winds. In position 3 (pulled out
: fully), set the Red GMT Hour Hand, the
: Minute Hand, and Hack the Second Hand. Then,
: push the crown into position 2 (center
: position) and set the regular Hour Hand. By
: turning the hour hand around the Dial two
: full revolutions, the Date will advance.
: This is how you set the date, and it will
: work forward or backward. Once the time is
: set, make sure you screw the crown in fully.

: The way I use the GMT: I usually have the Red
: GMT hand set to home time. The Red GMT hand
: is on a 24 hour cycle rather than a 12 hour
: cycle. The bezel is used for reading the GMT
: hand. When I travel and change time zones, I
: only reset the regular Hour Hand from
: position 2 (center position). This keeps the
: Red GMT hand reading my home time, and does
: not disturb the minutes or seconds. This
: same type of feature is available on many of
: the Omega Quartz movements.

: To read an additional time zone, I rotate the
: bezel. So I know my time zone (Pacific) is
: -8 hours of Greenwich Mean Time (Greenwich,
: England), I set the bezel to 8 and read the
: Red GMT hand to the bezel.

: Best WIS hes,

: Keith Downing

Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE