zOwie Omega Discussion Forum

This is my standard post on this subject. The results are easy to obtain and will result in minimal metal loss.

My solution for the removal of scratches was the purchase of fine and medium Satin Finish Bars from Frei and Borel on the TZ Tool shop. They are around 10 dollars (USD) each. They are hard sponge-like impregnated rubber blocks and I've had excellent results with them. For deeper scratches use their medium satin bar first. Its more abrasive. Finish up with long, slow, straight lines with the fine bar. The finish you'll get is extremely close to when new and should be a major improvement.

Be careful not to touch the crystal with it. DO NOT USE ON POLISHED SURFACES, only brushed. You don't take the links apart. You can refinish the brush look on the links by using a good light source, magnification if available, and by being very careful. If you don't think you're up to it, don't risk it! Also be careful of the engravings on the clasp.

The medium bar, and the fine bar to a lesser extent, is abrasive and continued use will take off metal over time.

The following is their text: 'This abrasive-impregnated rubber block provides the kind of brushed and satin finishes seen from the factory. I have never been able to reproduce it with any other abrasive of any type. The block, or squared pieces cut from it, should be used in very straight, light, even, uni-directional strokes over the entire length of the surface. Blow the surface free of debris between strokes for the most even finish. This is an indispensable product for those refinishing brushed and satined surfaces'

Fine Satin Bar
FB-1103

Around $10.60 USD

I've demonstrated the process for my authorized dealer and he agreed the results were excellent for very little effort. I gave him a chunk of mine to clean up any marks on his stock. I hope this helps.

Mark