The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
What size screwdrivers?
In Response To: Re: How To Open Case & Remove Movement/Dial ()

: David, it's pretty easy, but there is a lot of scope to make a
: massive boob. Just take your time and follow the instruction
: below.

: PS. don't blow on the dial, you'll get microscopic spit on it.. buy
: a watchmakers 'blower' - only a few £.

:
: http://www.chronocentric.com/forums/heuer/index.cgi?md=read;id=38582

: Cheers
: Stewart

Thanks Stewart, that's exactly what I needed! I'm assuming a Cal 14 will be the same?

How do I know what size screwdrivers to buy? Is there a "standard" watchmaking set?

Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE