The largest independent, non-commercial, consumer-oriented resource on the Internet for owners, collectors and enthusiasts of fine wristwatches. Online since 1998.
Informational Websites ChronoMaddox -- the legacy of Chuck Maddox OnTheDash -- vintage Heuer website Zowie -- Omega information
Discussion Forums ChronoMaddox Forum Heuer Forum Omega Forum
Counterfeit Watchers ChronoTools Forum ChronoTrader Forum
Vintage Heuer Discussion Forum
The place for discussing 1930-1985 Heuer wristwatches, chronographs and dash-mounted timepieces. Online since May 2003.
OnTheDash Home What's New! Price Guide Chronographs Dash Mounted Collection
Back-Plate for plastic Rally Master Pair

I'm not certain of what you are asking, but let me give it a go anyway.

With either the Monte Carlo or the Master Time, you will need a specially-made back-plate to mount the timer to a flat surface. There is a bayonet system, etc.

If you have each of these two timers on its own back-plate, then the question is whether you can consolidate them onto a double back-plate (with the bayonet system) or whether the two individual back-plates for the MC and MT can be mounted on a single plastic plate.

Have a look here --

And also see the photos below.



: I'm curious if anyone has the rally-master backplate (ref. 61) from
: the early 80's. Would like to see a photo of it by itself. Is it
: just a piece of high-impact black plastic? I've acquired both a
: Master-Time and Monte separately and wondering about the
: backplate, and whether it's even needed...

: Source: onthedash

Messages In This Thread

1980s Rally-Master Backplate (ref. 61) Question
Back-Plate for plastic Rally Master Pair
Re: Back-Plate for plastic Rally Master Pair
Current Position
Chronocentric and zOwie site design and contents (c) Copyright 1998-2005, Derek Ziglar; Copyright 2005-2008, Jeffrey M. Stein. All rights reserved. Use of this web site constitutes acceptance of the terms of use. CONTACT | TERMS OF USE | TRANSLATE